Internet of Things - Sensors and Devices

Practical 1 : To measure the room temperature using LM-35 temperature sensor

https://www.tinkercad.com/things/2ipM5tjR18Y-p1-temp-sensor sharecode=fDDrUTEhY4pgJHnaBS2KAjJkX3rnrbsLJ_RQV6flh2o 

Practical 2 : To interface LDR sensor with Arduino UNO board and control an LED based on the duration of day

https://www.tinkercad.com/things/dQnKvxGAykt-p2-ldr-controlling-led?sharecode=8RA2dIUWdxYjImUmmgJLYffvb7ppyBAfX_sZ1IGXzo0 

Practical 3 : Interfacing of PIR sensor with Arduino UNO and detect the presence of nearby object.

https://www.tinkercad.com/things/imhJDOwtQ3g-p3-obj-detect-pir-?sharecode=Q9IBMyPwXT7_RwGgocTfNDjwLMfXAsmfDxWOmMtMpcI 

Practical 4 : To interface soil moisture sensor with Arduino UNO and control an RGB LED

https://www.tinkercad.com/things/gItbcFlQoDQ-p4soil-moisture?sharecode=ytVQVRHjj0qrfHJ-EBujAzWwcPZUFvYZOZttShMmQOs 

Practical 5 : Interfacing of ultrasonic sensor with Arduino board and measure and display the distance of an object on serial monitor.

https://www.tinkercad.com/things/3s6f3Go4sPj-p5-ultrasonic-dist-measure?sharecode=mg4TnBQCu1sSUVEFKbTABD59zGaLLFiVDWST_PoP-QI 

Practical 6 : To interface MQ-2 gas sensor with Arduino UNO board and control the brightness of an led and sound of a buzzer based on amount of smoke being detected.

https://www.tinkercad.com/things/dkFGYWaVl9O-p6-smoke-detection?sharecode=MRI5gunLxDNR7KMZ3VU8VjxQPCzd1KusY6CHG9z2SgE 

Practical 7 : To interface DC motor with Arduino UNO board through a relay switch.

https://www.tinkercad.com/things/4H1cA9ZgK2v-p7-dcmotor?sharecode=DE4PQWwKbmio8Vm9BGJBObq4KX0BTqqlcFu4hpHc6cU 

Practical 8 : To interface flex sensor with Arduino UNO and display the amount of bending on LCD screen.

https://www.tinkercad.com/things/dZ0lhPaFCEq-p8-flexsensor?sharecode=leO7GvPSLGuOBuyi8aULCsZp6RaKdnGaVjzMLOLcGVs